FLUKE Process Calibration Tools Catalog | 2014-2015 - page 8

8 Electrical, Multifunction, and mA Loop Calibration
715
787
789
715 Volt/mA Calibrator
Outstanding performance,
durability and reliability.
• Measure loop current (0-20 mA,
4-20 mA) signals with very
high accuracy of 0.015% and 1
mA resolution
• Measure voltage output process
signals from PLCs, transmitters
• Source or simulate 24 mA loop
current
• Source voltage to 100 mV or 10 V
• 24 V loop supply with simultane-
ous current measurement
• Enhanced voltage and current
measure and source accuracy
• NIST traceable calibration
www.fluke.com/715
787 ProcessMeter ™
A complete troubleshooting solu-
tion in the palm of your hand
with a digital multimeter and loop
calibrator in one tool.
• 1000 V overload protection
on V, ohms, frequency
• 150 V overload protection on
mA, backed up by 440 mA
1000 V fuse
• 25 % manual step plus auto
step and auto ramp on mA
output
• CAT III 1,000V rating
www.fluke.com/787
789 ProcessMeter ™
The 789 includes all the popular
features of the 787 and adds:
• 24 V loop power supply
• 1200 ohm drive capability on
mA source
• HART mode setting with loop
power and a built-in 250 ohm
resistor
• 0 % and 100 % buttons to
toggle between 4 and 20 mA
sourcing for a quick span check
• CAT IV 600 V rating
www.fluke.com/789
771 Milliamp Process Clamp
Meter
Saves time by making fast, accu-
rate measurements on 4-20 mA
signal loops without breaking the
circuit.
• 0.01 mA resolution and
sensitivity
• Measure mA signals for PLC and
control system analog I/O
• Measure 10 to 50 mA signals in
older control systems using the
99.9 mA range
www.fluke.com/771
772 Milliamp Clamp Meter
Expanded features of the popular
771 mA Clamp Meter by adding
loop power and mA sourcing to
the capabilities.
• Measure 4 to 20 mA signals
with in-circuit measurement
• Simultaneous mA in-circuit
measurement with 24 V loop
power for powering and testing
transmitters
• Source 4 to 20 mA signals for
testing control system I/O or I/Ps
• Automatically ramp or step the
4 to 20 mA output for remote
testing
www.fluke.com/772
773 Milliamp Process Clamp
Meter
The premier mA clamp meter,
adds advanced troubleshooting
features and voltage source/
measure for testing voltage I/O.
Icludes all the features of the
772 plus:
• DC voltage sourcing and mea-
surement, verify 24 V power
supplies or test voltage I/O
signals
• Scaled mA output provides
a continuous mA signal that
corresponds to the 4 to 20 mA
signal measured by the mA
clamp
• Simultaneously source and
measure mA signals
www.fluke.com/773
771/772/773