Process Calibration Tools Catalog EN

8 Electrical, Multifunction, and mA Loop Calibration 715 710 mA Loop Valve Tester The Fluke 710 Valve Testing Loop Calibrator is designed to enable users to perform quick, easy tests on HART smart control valves. • Key valve testing functions include pre-configured valve signature test, speed test, step test, manual test, and bump/ partial stroke test • Key mA loop calibrator func- tions include mA source, mA simulate, mA read, mA read/ loop power, and volts read • ValveTrack™ Software enables upload to a PC for further in-depth analysis of valve mea- surements that are logged and recorded to memory www.fluke.com/710 715 Volt/mA Calibrator Outstanding performance, durability and reliability. • Measure loop current (0-20 mA, 4-20 mA) signals with very high accuracy of 0.015% and 1 mA resolution • Measure voltage output process signals from PLCs, transmitters • Source or simulate 24 mA loop current • Source voltage to 100 mV or 10 V • 24 V loop supply with simultane- ous current measurement • Enhanced voltage and current measure and source accuracy • NIST traceable calibration www.fluke.com/715 787B ProcessMeter ™ The Fluke 787B ProcessMeter™ doubles troubleshooting capabil- ities by combining the power of a digital multimeter and mA loop calibrator into one tool. • 20 mA dc current source/ measure/simulate • Simultaneous mA and % of scale readout • Fluke Connect ® compatibility for wireless data logging (with IR3000FC module) • Precision 1000 V, 440 mA true-rms digital multimeter • Frequency measurement to 20 kHz • Min/Max/Average/Hold/Relative modes • CAT IV 600 V/CAT III 1000 V rating www.fluke.com/787B 789 ProcessMeter ™ The 789 includes all the popular features of the 787B and adds: • 24 V loop power supply • HART mode setting with loop power and a built-in 250 ohm resistor www.fluke.com/789 771 Milliamp Process Clamp Meter Saves time by making fast, accu- rate measurements on 4-20 mA signal loops without breaking the circuit. • 0.01 mA resolution and sensitivity • Measure mA signals for PLC and control system analog I/O • Measure 10 to 50 mA signals in older control systems using the 99.9 mA range www.fluke.com/771 772 Milliamp Clamp Meter Expanded features of the popular 771 mA Clamp Meter by adding loop power and mA sourcing to the capabilities. • Measure 4 to 20 mA signals with in-circuit measurement • Simultaneous mA in-circuit measurement with 24 V loop power for powering and testing transmitters • Source 4 to 20 mA signals for testing control system I/O or I/Ps • Automatically ramp or step the 4 to 20 mA output for remote testing www.fluke.com/772 773 Milliamp Process Clamp Meter The premier mA clamp meter, adds advanced troubleshooting features and voltage source/ measure for testing voltage I/O. Icludes all the features of the 772 plus: • DC voltage sourcing and mea- surement, verify 24 V power supplies or test voltage I/O signals • Scaled mA output provides a continuous mA signal that corresponds to the 4 to 20 mA signal measured by the mA clamp • Simultaneously source and measure mA signals www.fluke.com/773 771/772/773 787B/789 710