8
Electrical, Multifunction, and mA Loop Calibration
715
787
789
715 Volt/mA Calibrator
Outstanding performance,
durability and reliability.
•
Measure loop current (0-20 mA,
4-20 mA) signals with very
high accuracy of 0.015% and 1
mA resolution
•
Measure voltage output process
signals from PLCs, transmitters
•
Source or simulate 24 mA loop
current
•
Source voltage to 100 mV or 10 V
•
24 V loop supply with simultane-
ous current measurement
•
Enhanced voltage and current
measure and source accuracy
•
NIST traceable calibration
www.fluke.com/715787 ProcessMeter
™
A complete troubleshooting
solution in the palm of your hand
with a digital multimeter and loop
calibrator in one tool.
•
1000 V overload protection
on V, ohms, frequency
•
150 V overload protection on
mA, backed up by 440 mA
1000 V fuse
•
25 % manual step plus auto
step and auto ramp on mA
output
•
CAT III 1,000V rating
www.fluke.com/787789 ProcessMeter
™
The 789 includes all the popular
features of the 787 and adds:
•
24 V loop power supply
•
1200 ohm drive capability on
mA source
•
HART mode setting with loop
power and a built-in 250 ohm
resistor
•
0 % and 100 % buttons to
toggle between 4 and 20 mA
sourcing for a quick span check
•
CAT IV 600 V rating
www.fluke.com/789771 Milliamp Process Clamp
Meter
Saves time by making fast, accu-
rate measurements on 4-20 mA
signal loops without breaking the
circuit.
•
0.01 mA resolution and
sensitivity
•
Measure mA signals for PLC and
control system analog I/O
•
Measure 10 to 50 mA signals in
older control systems using the
99.9 mA range
www.fluke.com/771772 Milliamp Clamp Meter
Expanded features of the popular
771 mA Clamp Meter by adding
loop power and mA sourcing to
the capabilities.
•
Measure 4 to 20 mA signals
with in-circuit measurement
•
Simultaneous mA in-circuit
measurement with 24 V loop
power for powering and testing
transmitters
•
Source 4 to 20 mA signals for
testing control system I/O or I/Ps
•
Automatically ramp or step the
4 to 20 mA output for remote
testing
www.fluke.com/772773 Milliamp Process Clamp
Meter
The premier mA clamp meter,
adds advanced troubleshooting
features and voltage source/
measure for testing voltage I/O.
Icludes all the features of the
772 plus:
•
DC voltage sourcing and mea-
surement, verify 24 V power
supplies or test voltage I/O
signals
•
Scaled mA output provides
a continuous mA signal that
corresponds to the 4 to 20 mA
signal measured by the mA
clamp
•
Simultaneously source and
measure mA signals
www.fluke.com/773771/772/773